Cyanoacrylate

.5oz Maxi-Cure Extra Thick Cyanoacrylate

Maxi-Cure™ extra thick CA is the best CA for most plastics, including GE’s Lexan MAXI-CURE™ is the best choice for plastic model assembly. When used with INSTA-SET™, it works better than any putty for modifying or filling voids...

.5oz Insta-Cure+ Medium Gap Filling Cyanoacrylate

Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface...

.5oz Insta-Cure Super Thin Cyanoacrylate

Insta-Cure™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the...

2ft PTFE Capillary Tubing

2ft PTFE Capillary Tubing - #305 (1 pc) For use over the standard #312 top (not included) & CowRC's thin CAs (Insta-Cure/Insta-Flex) allowing precise application.

Regular Extender Tips

Regular Extender Tip - #301 (6 pcs) For use over the standard #312 top, it allows CowRC's CAs (Insta-Cure/Insta-Flex) to be applied a drop at a time. CA tend to run, these allow precise application.

Extra Long Extender Tips

Extra Long Extender Tip - #303 For use over the standard #312 top, they provide a rigid tip with extended length to get thin and gap filling CA into hard to reach areas. They are very resistant to clogging and can be cleaned by soaking in acetone.

Extra Fine Extender Tips

Extra Fine Extender Tip - #302 (6 pcs) For use over the standard #312 top, it allows CowRC's thin CAs (Insta-Cure/Insta-Flex) to be applied a drop at a time. Thin CA tends to run, these allow precise application.

Non-Clog CA Applicator (Regular Tip)

Regular Tip Non-Clog CA Applicator - #321 Regular Tip Non-clog 6" long pipette for the application of gap filling and extra thick CAs. CA is loaded by inserting into an open CA bottle with bulb compressed, similar to an eye dropper. 

Non-Clog CA Applicator (Fine Tip)

Fine Tip Non-Clog CA Applicator - #322 Fine Tip Non-clog 6" long pipette for the application of thin CAs. Can also be used for the fine application of Insta-Set accelerator and for applying fine lubricating oils. CA can be kept in the applicator for...

Extra CA Top

Extra CA Top - #312 Replacement top that is on all of BSI's non-pocket Cas. Tops can be soaked in acetone overnight to remove any buildup of CA on the inside and outside of the nozzle.